Wednesday, March 14, 2012

What to do with a broken pot? (project)


So while transplanting all my house plants back into their outdoor porch pots, I picked up one of my favorite glazed clay pots to find it split in 2. It was an almost perfect split! Now, usually during a situation like this I find myself searching pinterest or google for ideas for broken pots. I've done mosaics, tiled tables, buried them... I even could have gorilla glued this along the seam and it would have been good enough to use a couple more years. No chips or broken pieces... a perfect split I tell ya!!!

I just HAPPEN to look over at my plaster end tables next to my bench that were about to be spring cleaned for the season and thought, well now.... I could REALLY bump up the end tables by planting them too. So I got to work turning my end tables into multi-use planters.


Step 1. - CLEAN everything. We're using adhesive here, and the surface needs to be spotless, dirtless and dustless.

Step 2. Rough up the area on the tables you need the pot to adhere to. Make some grip for your adhesive. Try a low grit sandpaper.

Step 3. Adhesive! In this situation your basic glue, hot glue or caulk won't work. "Water tight" is not ok. If water and dirt pool inside the pot caulk will warp and eventually release your pretty pot. Seeing the pot is clay and the table I have plaster... I went with a cement adhesive/fixer and expandable sealant. This is meant for brick, driveways, stairs... things that are going to get weathered regularly and it will hold even with pooling water for years. Check out the pic for the one I found, Home Depot has it in their cement/mortar aisle for about $6. Make sure to add a thick amount to all the areas that tough. The more the merrier with this stuff!





Step 4. Allow to cure! The can says 6 hours for basic sure... 10 days for FULL cure. I gave it 24 hours before I stood them up. Then 2 more days before I went on to the next step.




Step 5. Time to fill. As you see, my perfect crack was kinda wavy so they don't sit flat. I was going to fill with the adhesive on the sides, but thought better of that. The soil would slip fall out the bottom. So what to do to keep soil retention, and still allow drainage? Metal hanging pot liners!  I just HAPPEN to have a bunch of old ones needing to be replaced so I took 1 out of a long basket, cut it in half and used this to line the pots before adding the soil. Walla!



Step 6. Fill your planter tables! I chose a long growing ground cover vine called Vera. It will spill over the pot to the base of the porch and not grow up so the top of the table is clear to put things on.

So now you have a broken planter idea that is pretty budget friendly. This should work with wood tables as well, but you may have to experiment with the adhesive you use. My original plant with these was to use grout, but they didn't have it in a tube (it is out there though!) so I had to come up with a second idea on the fly.


Enjoy!

2 comments:

  1. what a neat idea! looks great!

    ReplyDelete
  2. What a clever idea! They turn out beautifully!
    Also, I want to thank you for leaving a comment on my blog.
    Have a wonderful spring!

    ReplyDelete